Tagger Set Up

Owned by Errin Evans (Unlicensed)
Last updated: Oct 10, 2023
1 min read

Set Up an Edge Device

  1. Power on the device. Confirm lights are active on the box.

Note: The Fitlet light will be green if connected to power AND powered on. The light will be amber if connected to power but powered off.

  1. Confirm the device shows up on the User Interface.

    1. Navigate to Admin page/Devices tab

    2. Box may show as unassigned or want to connect to its original assignment (if swapped from another location).

  2. Confirm antenna is connected.

New boxes have two, redundant antenna connections. If using one antenna, the connection closest to the side is preferred over the one at dead-center.

  1. Ensure box is connected to data feed. If swapping a box, ensure connected in same places as the replaced box.

If seeing an error, rule out local communication errors (i.e., not an issue with the serial port or ethernet physical connections).

  1. Contact Specific Energy Tech Support to confirm connection.

 

Not quite what you need? Return to the Help HOME Screen.